Switch on PLC controller, will display below interface. You can set the transfer parameter as you need.
After you set down the transfer parameter, there are 3 modes for choose: Manual mode, Semi-auto mode and Auto mode. Here is the operation instruction for 3 different mode:
Manual Mode:
First press 
,then long press 
until the bottom plate in place. Press
and then begin to transfer. After transferring, long press 
to put the up plate in place, and then press 
for new transfer.
Semi-auto mode:
First press 
, and then long press
until the bottom plate in place. Press 
,and then press the two green button at the same time to begin transfer process.
Auto mode:
For this mode, just only to press 
to do the transfer.
Any interest in it or any questions, please do not hesitate to contact :
Website: www.microtecgroup.com
Email: inquiry@szmicrotec.com
